Hi everyone, in this bridal special tutorial I am going to show how to make “fuchsia flower”. we are going to make bridesmaid bouquet, So lets get started.
Things we need :
- Pink coloured 4cm(width) organza ribbon,
- Purple 2cm(width) organza ribbon,
- Deco 12cm(width) Organza ribbon,
- Hot glue gun and glue sticks,
- 10 mm Wire flower stems (16),
- Lighter or Candle,
- facial cotton pads,
- needle and thread,
- Green tape,
- Artificial flower stigmas.
Step 1: Cut about 10cm of pink organza ribbon. Using lighter singe the ends together.
Step 2: For making bud, stitch a circle running stitch in the pink organza ribbon.
Step 3: Pull the thread carefully half way through, stuff facial cotton bud.
Step 4: Apply some glue on the cotton, place the wire in the middle pull the thread stitch firmly. Using the green tap wrap the wire.
Step 5:Now lets begin with the inner petals. take the purple organza ribbon using needle and thread make running stitch. just as shown in the images.
Step 6: Try to pull the thread through carefully and stitch both the ends together.
Step 7: Cut about 10cm of pink organza ribbon. Using lighter singe the ends together. Make a running stitch just as shown below.
Step 8: Using scissors make a tiny hole in the middle of the ribbon. This is going to be our outer petal. Do not cut the thread at the end.
Step 9: Cut about 4-6 cm of wire in length. Make a loop at one end of the wire. place two stigma in the middle , using the clipper secure the wire.
Step 10: Apply hot glue at the end of the stigma and stick purple petals ring which we made earlier.
Step 11: Now place the pearl through the wire.
Step 12: Pass the outer petal through leaving the pearl inside stitch firmly. Now we can cut the extra thread.
Step 13:Apply hot glue at the end of the purple petal and stick pink outer petal.
Step 14:Using the green tap wrap the wire.
Step 15: Now all the flowers are ready.
Step 16:Take the pink organza ribbon fold and make the running stitch along one side of the ribbons making double layer.Once you reach the other end. Pull the thread through carefully.
Step 17:This will make a small gathering. once you have pulled all the ribbon through, make a knot at the end.Cut the remaining thread using scissors.
Step 18:Gather the flower together and place the ribbon ring though in place.
this fuchsia bouquet will add some more beauty to our gorgeous bridesmaid.
Thank you for reading this tutorial, Please like us and share your experience through social media. Give a thumbs up .Check our facebook page